Visonic AmberLink User's Guide download pdf (Page 24)

D-303166 AmberLink™ User Guide 23

APPENDIX D: COMPLIANCE and STATEMENTS

Compliance

§ 15.19(a)(3)

§ 15.21

Statement

Changes or modifications to this equipment not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

5. For a Class B digital device the instructions furnished the user shall include the following or

similar statement, placed in a prominent location in the text of the user or instruction manual:

§ 15.105

Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Due to FCC requirements in the U.S.A. and IC in Canada, transmission power is limited. This

limited power output should provide a maximum operating range of 400 feet in "open space".

This range may be reduced further when operating within buildings, or around other obstructions

to R.F. signals. Other operating frequencies as approved for use in other parts of the world have

a higher allowed transmission power which can result in greater range.

This equipment should be installed in accordance with Chapter 2 of the National Fire Alarm

Code, ANSI/NFPA 72.

AmberLink

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Visonic AmberLink User's Guide Page 24