Visonic POWERART Specifications download pdf (Page 5)

DE5458 5

panel from the bracket will start a tamper alarm. Forcibly

removing the entire assembly off the wall will also start a

tamper alarm, because the joints of the ring and cam

piece to the bracket leg will break off, leaving the ring and

cam attached to the wall.

Figure 8. Bracket - Front View

C. Attaching the Bracket to the Wall

Choose a concealed place, yet easily accessible to

prospective users of the alarm system. Make sure that an

uninterrupted AC power outlet and a telephone line socket

are available near the installation spot.

Use the bracket as a template to mark the drilling points.

Drill the holes and attach the bracket to the wall with 4

screws. Be sure to insert the special plastic washer into

the ring, as shown in Figure 8.

3.5 Wiring

All terminals and connectors are accessible within the

opening at the back of the PowerArt™ (see Figure 9). All

screw terminal blocks (except for “EARTH”) can be pulled

out, wired appropriately and plugged back in.

WARNING! When plugging terminals back

into place, be sure to align them carefully

with the pins on the PCB. Mis-aligned or

reverse insertion of terminals may damage

internal PowerArt™ circuits!

The telephone-type connectors are also easy to deal with,

because of their quick attach/detach capability.

Figure 9. Sunken Wiring Area Layout

Figure 10. Wiring Diagram

Important Note (applicable in the U.S.A only): The earth ground terminal must be connected to a good earth ground to

allow effective protection against lightning transients.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Visonic POWERART Specifications Page 5